Woodworking machine maintenance steps

Woodworking engraving machine is mainly used for wood processing, crystal, copper, aluminum, etc., making it more beautiful. In order to make woodworking engraving machine run more efficiently, it needs frequent maintenance. Let's take a look at the maintenance steps of woodworking engraving machine:

1, unplug the power cord, safety first.

2. Remove the plastic sheath and take the Phillips screwdriver counterclockwise to unlock the two screws.

3, take a word screwdriver to solve the pair of carbon brush screws counterclockwise, use a needle-nosed pliers to remove the carbon brush, carefully remember the carbon brush installation position, recovery is smooth.

4. Use a brush to clean the dust on the carbon brush. Spray it with an air spray gun.

5, the shell should be slightly forced to open.

6, use your fingers to screw the motor shaft, whether there is a touch of the machine, metal friction sound.

7, to determine that there is no dust, use the universal needle car oil, drop a little bit into the seam on the ring, the finger spins down the shaft to ensure that the oil eats in.

8. Wipe off the remaining oil, otherwise wipe the dust in the future.

9. Follow the steps above to restore the device.

10, after the screw is locked, first screw it with your finger to see if it is not smooth, the carbon brush is good, and it is determined that there is no abnormality.

11, plug in the power, the boot sound is normal!

How should woodworking engraving machine be cleaned up?

    When the engraving machine is in use, it is to be cleaned, especially the woodworking engraving machine. why? Because it is easy to produce wood chips when using the engraving machine, it is easy to block if it is not cleaned before reuse, thus affecting the use effect of the engraving machine. So how should this engraving machine be cleaned up?
    Woodworking machine manufacturers recommend that everyone, the most important part of the cleaning is the slide of the machine tool. Because the wood block is fixed on the machine when the engraving machine is working, it is easy to produce various kinds of wood chips on the machine tool when engraving, and then fall on the slide of the machine tool, causing the problem of blockage. Therefore, when cleaning the engraving machine, it is possible to focus on cleaning the slides on both sides of the machine to ensure that no wood chips are stuck inside, which affects the use of the engraving machine.
    In addition to the machine's slides need to clean wood chips, other gears and slides should also check for wood residue, if any, in time. When the engraving machine is designed, there are many gears and slides. These places are easily caught by wood chips. Therefore, it is necessary to check and clean these places in time to ensure the use of the machine. However, the cleaning of these places does not need to be too frequent, and it can be checked once in a while. The machine tool must be cleaned after each engraving.