Engraving machine winter maintenance

      The daily maintenance of the engraving machine is very important, and the formation of good maintenance habits can keep the engraving machine in good working condition and greatly extend the life of the engraving machine. After entering the winter, the temperature is getting lower and lower, is your engraving machine well maintained in winter? Today we will talk about the winter maintenance of the engraving machine.
If your engraving machine is not used for a long time, it should be refueled regularly to ensure the flexibility of the transmission system. After the oil is added, move slowly back and forth to ensure that the lubricant can be evenly applied to the guide rail and the lead screw.

      In the winter maintenance of the engraving machine, first clean the guide rails and the lead screws, and clean them off with the cloth (no hair removal) bar and the oil and material scraps on the screw. Due to the low temperature, both the guide rail and the lead screw can be added with oil. It is best to add antifreeze oil.

      The influence of temperature on the engraving machine is not very big, but because many customers add butter to the screw, they forget to clean up in winter, which leads to the opening of each boot. Some studios have low temperature. Although the oil is added, it can still be frozen. On, the machine can't run. Therefore, we should try to ensure the ambient temperature of the operation room, preferably to reach the room temperature, at least the staff will not be very cold. Check the applicable temperature of the fueling standard, at least the minimum temperature. When the machine is not in use, it is best to pour out the water in the water tank if the room temperature is low, to prevent freezing of the water tank and the water pipe.

      Many customers often forget that the embossing engraving machine changes water, especially in autumn and winter. Because the outside temperature is low, the spindle motor is too hot to feel. We hereby remind customers that cooling water is a necessary condition for the normal operation of the spindle motor. Dirty can cause serious damage to the motor, ensuring the cleaning of the cooling water and the normal operation of the pump. Pay attention to the water level, and the water-cooled spindle motor must not be dehydrated, so that the motor heat cannot be exported in time. Pay attention to the ambient temperature. Be careful to freeze the water tank and water pipe due to the water temperature being too cold. It is possible to use antifreeze to cool.